cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2446
Views
0
Helpful
2
Replies

Error during boot IOS on ASR1002

Rojer-bkk
Level 1
Level 1

Hi Expert,

During the boot ios we found the error messages below. How can i clear this messages?

 

Missing or illegal ip address for variable DEFAULT_GATEWAY Using midplane macaddr

Missing or illegal ip address for variable IP_ADDRESS

Missing or illegal ip address for variable IP_SUBNET_MASK

1 Accepted Solution

Accepted Solutions

Rozsa Illes
Cisco Employee
Cisco Employee

Hello,

Those messages will not cause any harm. Based on their nature, they should be cleared if you set the parameters for booting from TFTP server in Rommon but I have not done it yet myself.

If you are still interested, this link explains how it is configured and how the boot would look like on an ASR:

http://www.cisco.com/en/US/partner/docs/routers/access/2600/hardware/installation/guide/2600appB.html#wp1042476

http://www.cisco.com/en/US/partner/docs/routers/asr1000/quick/start/guide/asr1_qs6.html

I could not find a way to configure them from CLI and I do not think that going into rommon is really worth the effort just so that those messages disappear.

Warm Regards,

Rose

View solution in original post

2 Replies 2

Rozsa Illes
Cisco Employee
Cisco Employee

Hello,

Those messages are normal and they do not indicate any problem. They are printed by the rommon code to indicate that it is not setup to boot from tftp server.

Warm Regards,

Rose

Rozsa Illes
Cisco Employee
Cisco Employee

Hello,

Those messages will not cause any harm. Based on their nature, they should be cleared if you set the parameters for booting from TFTP server in Rommon but I have not done it yet myself.

If you are still interested, this link explains how it is configured and how the boot would look like on an ASR:

http://www.cisco.com/en/US/partner/docs/routers/access/2600/hardware/installation/guide/2600appB.html#wp1042476

http://www.cisco.com/en/US/partner/docs/routers/asr1000/quick/start/guide/asr1_qs6.html

I could not find a way to configure them from CLI and I do not think that going into rommon is really worth the effort just so that those messages disappear.

Warm Regards,

Rose

Review Cisco Networking products for a $25 gift card