Hi Experts, Please find topology attached.we have 1 MPLS line and 1 Site to Site VPN (as backup) connected from head office to branch officeWe want to monitor ping delay on interface GigabitEthernet1/0/23 whose ip address is 172.16.2...
Hi, Which dynamic routing is the best, EIGRP or OSPF and why ? How can we use both of the routing in same router ? What is the best practise ? Thanks in advance, Bikas
HiI am confused and any help would be great!What is the difference between IP throughput routing throughput and firewall throughputthe reason is i am trying to spec a router for a mate who is setting up an online server for an old game ultima online ...
Hello All,I am trying to setup a dual site multihomed network. Attached is the diagram showing topology and how the routing tables are anticipated to be populated using BGP and static routing.The site on the left (mas11/12.gw) is primary site and one...
Hi thanks for taking a minute to consider helping .I have an MPLS WAN using BGP and some static routes. I am looking to configure a backup route on the MPLS router to use a VPN tunnel on my ASA as a fail over. I have done this years ago but forgot wh...
Hi,I need to know if it posible, in the RV series routers, like the RV042 for example, to configure a VPN automatic reconnection after suffering a WAN link lostd recovery.Thank you very much.Necesito saber si en los routers de serie RV, como por ejem...
I got this issue where i got a head end device and a remote end.Head end Dial_Backup#sh ip eigrp neighborsIP-EIGRP neighbors for process 10H Address Interface Hold Uptime SRTT RTO Q Seq Type ...
I'm setting up a multi-home scenario:1) One site2) /24 IP prefix3) Registered, public AS4) Two links (two different ISPs) - ISP A and ISP B5) iBGP between them6) ISP A should be primary for all inbound and outbound traffic7) ISP B should be backup fo...
Hi Expert,We have implemented hsrp in our networ. We are using HSRP tracking functionality ( tracking serial interface). I want to know how much time standy router take to get active state when serial link get down.Thanks in advance.Surya
About 4 months ago or so I had what I though was a firewall problem, tuned out to be two bad switches or so I thought. I replaced the switches with 3 com switches and everything seemed fine. Until Monday, my network was down again I though because I ...
Hello,I've noticed that in order for a routing policy to take effect, the bgp peer connection must be cleared first. This is not practical of course in production environment. For example, using route maps to filter a specific NLRI or to set communit...
Ok, here goes:I have a vrf that I've configured to use a certain tunnel. I've verified that traffic is moving over the tunnel. When I put my bgp next-hop under the vrf, I lose all traffic across the tunnel. I'm running eigrp between the ce-pe, so I'm...
If we swap T1/E1 lines in a router, like say disconnecting an old line & connecting a new PRI when say moving office, is a change of config needed in the Voice gateway where these lines are connected?
