12-12-2012 09:18 AM - edited 03-04-2019 06:23 PM
I purchased several 1921 routers and the last two I setup get the following error during bootup:
%SYS-6-READ_BOOTFILE_FAIL: tftp://255.255.255.255/1:aaa1386.bin No usable interfaces.
%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.
%MAINBOARD_GE-3-SHUTDOWN: FPA PKT pool holding 512 particles.boot of "1:aaa1386.
bin" using boot helper "usbflash0:c1900-universalk9-mz.SPA.151-4.M4.bin" failed
error returned: No usable interfaces
loadprog: error - on file open
boot: cannot load "1:aaa1386.bin"
The router moves on and eventuall comes up fine and is operational. Does anyone know what this error is an if I can get rid of it?
12-13-2012 07:32 AM
Check boot statement in configuration.
12-13-2012 08:28 AM
Yes I did try to remove the statement in the boot start section but it will not remove.
12-13-2012 12:20 PM
Try again and post details.
12-13-2012 01:16 PM
I finally got it out. After going into Config t I was typing boot-start-marker and then no 1:aaa1386.bin. It would take the statement but would not remove the line. Then I tried just doing no 1:aaa1386.bin from the Global config and it took it.
Thanks
12-13-2012 02:06 PM
You're welcome, please remember to rate useful posts clicking on the stars below.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide