Dear Members:
We are planing to replace ESP100 by ESP200 in one of our router [ASR 1009-x] for upgrading the overall througput.
Can anyone please explain the total procedure/dependency in breif or share a good link to start?
And we have few specific question as well if possible please share insight
- Currently we have single RP in RO slot and single ESP100 on FO slot. so if we insert the ESP200 on F1 slot and then remove ESP100 from FO slot will it work or we have to remove the ESP100 from FO slot and insert the new ESP200 on FO slot?
- Can we insert the new ESP200 while router power on?
- Do we need to reboot the router after ESP200 insertion completes?
- Any license required or only insertion of ESP200 is good enough?
output of show platform command from the router is shared below for your kind observation
aggregation.gw#show platform
Chassis type: ASR1009-X
Slot Type State Insert time (ago)
--------- ------------------- --------------------- -----------------
0 ASR1000-6TGE ok 31w4d
0/0 BUILT-IN-6TGE ok 31w4d
1 ASR1000-SIP40 ok 31w4d
1/0 SPA-8X1GE-V2 ok 31w4d
1/1 SPA-1X10GE-L-V2 ok 31w4d
1/2 SPA-1X10GE-L-V2 ok 31w4d
1/3 SPA-1X10GE-L-V2 ok 29w4d
2 ASR1000-6TGE ok 4w2d
2/0 BUILT-IN-6TGE ok 4w2d
R0 ASR1000-RP3 ok, active 31w4d
F0 ASR1000-ESP100 ok, active 31w4d
P0 ASR1000X-AC-1100W ok 31w4d
P1 ASR1000X-AC-1100W ok 31w4d
P2 Unknown ps, fail never
P3 Unknown ps, fail never
P4 Unknown ps, fail never
P5 Unknown ps, fail never
P6 ASR1000X-FAN ok 31w4d
P7 ASR1000X-FAN ok 31w4d
P8 ASR1000X-FAN ok 31w4d
Slot CPLD Version Firmware Version
--------- ------------------- ---------------------------------------
0 14011701 16.2(1r)
1 00200800 15.3(3r)S
2 14011701 16.2(1r)
R0 16082219 16.3(2r)
F0 12071700 16.2(1r)
Thanking,
Palash