Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
457
Views
0
Helpful
1
Replies

Frame Relay - RV016

mauricioagra
Level 1
Level 1

‎12-15-2009 06:34 AM - edited ‎03-04-2019 06:58 AM

Dears, I would like to know if I can configure the router linksy - Cisco to receive a Frame Relay link?

The protocol is sent pel PPP provider as part of a configuration below, which I received from the provider.

Protocol MLPPP / Routing / Static Routing Balancing NO / Address Block (LAN) 192.168.4.0 / Address Mask 255.255.255.0 / Topology Full MeshedQoS NO.

Labels:
0 Helpful
1 Reply 1

Giuseppe Larosa
Hall of Fame
Hall of Fame

‎12-28-2009 01:12 AM

Hello Mauricio,

after reading the service provider specifications I would say you should configure your device with encapsulation PPP or multilink PPP rather then frame relay.

It is possible to run PPP over Frame Relay but I don't know if this is your case.

Hope to help

Giuseppe

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card