01-22-2016 04:02 PM - edited 03-05-2019 03:11 AM
Hi everyone
I am trying to figure out if some of my VLAN interfaces are having issues. I was looking for packet loss and saw the following on some of my VLANs, see orange highlights below. I am get very high numbers for my tx and rx loads, but my reliability is still 255/255. Is this an issue? I can't find anything online about VLAN interfaces having high tx or rx loads.
Thank you
Luis
Vlan12 is up, line protocol is up
Hardware is Ethernet SVI, address is b07d.4700.1567 (bia b07d.4700.1567)
Internet address is X.X.12.1/24
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 255/255
Encapsulation ARPA, loopback not set
Keepalive not supported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters 9w1d
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 1399548000 bits/sec, 131394 packets/sec
5 minute output rate 205000 bits/sec, 122 packets/sec
731866565450 packets input, 976358742737824 bytes, 0 no buffer
Received 0 broadcasts (30873 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
904589193 packets output, 458849071216 bytes, 0 underruns
0 output errors, 0 interface resets
0 unknown protocol drops
0 output buffer failures, 0 output buffers swapped out
and
Vlan15 is up, line protocol is up
Hardware is Ethernet SVI, address is b07d.4700.1554 (bia b07d.4700.1554)
Internet address is X.X.15.1/24
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 249/255
Encapsulation ARPA, loopback not set
Keepalive not supported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters 9w1d
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 979204000 bits/sec, 91685 packets/sec
5 minute output rate 147000 bits/sec, 90 packets/sec
494602899301 packets input, 661946671057181 bytes, 0 no buffer
Received 0 broadcasts (19808 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
440301572 packets output, 103441792223 bytes, 0 underruns
0 output errors, 0 interface resets
0 unknown protocol drops
0 output buffer failures, 0 output buffers swapped out
Solved! Go to Solution.
04-26-2016 08:30 PM
Luis,
Thanks for your information. But any method for solving this problem?
Richard,
In my environment, it is also related to video editing. So any recommended model of access swtich from you? Thanks a lots
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide