How to do the bandwidth test below

axus123456 · ‎09-25-2014

Hi,

I got this test below from a customer, I understand the test below but the thing is I do not know how to do it,

Please can you help me on how to do the test below on WAN link using a Cisco router.

2. xxx.xxx.xxx.xxx GigabitEthernet0/1 0 0 0 0 2544000 304 2669000 407 0

3. xxx.xxx.xxx.xxx GigabitEthernet0/1 0 0 0 0 3343000 402 3634000 536 0

4. xxx.xxx.xxx.xxx GigabitEthernet0/1 1 0 0 0 1856000 354 2088000 471 0

5. xxx.xxx.xxx.xxx GigabitEthernet0/1 0 0 0 0 282000 38 282000 38 0

9. xxx.xxx.xxx.xxx GigabitEthernet0/1 0 0 0 0 42000 39 42000 38 0

Joseph W. Doherty · ‎09-25-2014

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Test?

Hmm, looks like show interface summary stats.

e.g.:

switch#sh int sum

*: interface is up
IHQ: pkts in input hold queue     IQD: pkts dropped from input queue
OHQ: pkts in output hold queue    OQD: pkts dropped from output queue
RXBS: rx rate (bits/sec)          RXPS: rx rate (pkts/sec)
TXBS: tx rate (bits/sec)          TXPS: tx rate (pkts/sec)
TRTL: throttle count

Interface           IHQ   IQD OHQ   OQD RXBS RXPS TXBS TXPS TRTL
---------------------------------------------------------------------
* Vlan1                 0     0    0     0 3000    6 26000   34 1336
* FastEthernet0/1       0     0    0     0 2000    1 4000    3    0