Routing

Hi,I have a Cisco 1841 router and one WIC-1SHDSL Card. We have ADSL internet connection though ISP but i am unable to connect using this card. What i believe is that this WIC does not supports ADSL/ADSL2/ADSL2+ connection types. Below is my configura...

Hello,i want to ask for this:On ASA version 8.2.1 is configured static translation like this:static (Inside,Outside)  5.5.5.100 192.168.1.5 netmask 255.255.255.255what is a static 1:1 mapping between Outside and Inside IP.This translation create mapp...

Hi All,We have a plan to implement dynamic VLAN for our wired users. We have a headcount of around 6000 users. Can you please suggest what hardware we can go with to achieve this setup. As of now we have 2960 at access layer and Windows 2012 R2 AD co...

Hello,Can someone please, tell me if the license 76-ES+ADVIP-LIC contains a KEY ACTIVATION, and if it is possible to transfer the key  from a card to the other one in case of failure? This is what i can find, but not really clear.http://www.cisco.com...

Hello,I am going to configure the NATing on ASR1002 and expecing to have near about 1Million nat translation. Will ASR1002 support 1million nat translations ?Any idea how many NAT translations are supportable on the ASR1002 ?I am going to configure N...

1. Are all OSPF Routers suppsed to see networks in All OSPF areas? 2. Should all loopbacks be configured in the same area?

Hi,We need to setup Cisco 2911 router as a console server for OOB (Out of band) connectivity to console of each DC device (upto 20 devices) Could someone please respond to the following questions we had:1. What interface module can we install on the ...

Hi everyone,don't know if I'm just stupid or have hit a bug...I was faced with the request to help out our training department. They will conduct a training in a new facility this week and the ISP did not deliver DSL on time. The training facilities ...

We're trying to install a network with a Cisco 2921 router and two Cisco 3750 switches for use with a data and voice vlan that need access to the internet. The phones are polycom phones which download their firmware/configuration and register through...

Hello,Reading into OSPF again after not touching it for a while.From what I'm reading - Stub area, allows LSA 1 and 2 within the stub area and the ABR sends LSA 3 into the stub area. This LSA 3 is a default route - 0.0.0.0 /0 pointing to the ABRA Tot...

Hi,I have recently purchased ASR1002-RP1-ESP5 with 2 x 4K Broadband licenses to be used as LNS. Cisco have sent me PAK files for the licenses however when I try to enter the licenses into the device I get an error message saying that Licensing is not...

I saw in the release notes that 3.10 for the ASR 1001 supports port-channel for the internal otv interface.  I upgraded to that release and it lets me use a port-channel interface, but it won't let me use the serivce instance command on the L2 interf...

We have a Cisco ASR 1002 router.While we have configured it the local interface is not pinging and nor is the remote IP address pingable.What could be the issue ?  

Hello I have problem similar to this one https://supportforums.cisco.com/thread/2014060Detail: I have WS-C3560E-12D & try to install Xetnpack to BASE-T X2-10GB-T. In the port status I see err-disabled.I try to c3560e-universalk9-mz.150-2.SE4 & c3560e...