HSRP CCNA (R&S)

anupamjha254@yahoo.com · ‎02-03-2018

I am unable to ping R2 from R4,i had removed routing from R4 and considered it as an end device.Please help me why i can't ping R2 from R4,what is the problem,80.0.0.1 is taken as loopback on R2.Im getting the error as (UNRECOGNISED HOST OR ADDRESS,PROTOCOL NOT DEFINED) on pinging R2 from R4.

Jon Marshall · ‎02-03-2018

Post router configs and diagram of connectivity.

Jon

Predrag Jovic · ‎02-03-2018

Are any interfaces on device from which you are trying to ping in up up state?

anupamjha254@yahoo.com · ‎02-04-2018

Yes all are in up state with Eigrp config. on them

Predrag Jovic · ‎02-07-2018

Similar messages I saw only in the case that IP address is not present on device, or all interfaces are down. I guess this is root cause for warning message.

This was output with interfaces down, no IP addresses present on router.

ping 1.1.1.1
% Unrecognized host or address, or protocol not running.

So, can you, please, provide running configurations?

Georg Pauwen · ‎02-04-2018

Hello,

do you have ip routing enabled globally ?

R4#conf t

R4(config)#ip routing

?