04-20-2017 01:34 PM - edited 03-05-2019 08:23 AM
Hello Everyone,
I just tried to setup HSRP Load sharing in Cisco Packet Tracer.
I have allowed VLAN 10 to go through Router R1 and VLAN 20 to go through R2. Have Setup HSRP Group 10 and 20 on both Router.
R1 configured as primary for Group 10 to carry the traffic of VLAN 10 and R2 configured primary for Group 20 to carry traffic for VLAN 20.
Routers are well taking the HSRP Roles as per the scenario configured . ..
problem is that when I am trying to ping intervlan, it is not working from both PC.
Even tried to ping the Virtual IP configured as GW to the PC's. Unable to reach.
Tried to review the config on Devices but no joy.
Wondering if someone can help to clarify my mistake .....
Attached is the Topology, configs and PKT(Packet tracer file in File.Zip ) for your reference.
Regards
Rizwan
Solved! Go to Solution.
04-20-2017 08:00 PM
Hello,
I tested your zip file. It worked with packet tracer 6.2. You need to wait a little bit after pinging.
I could ping both PCs from each other.
Masoud
04-20-2017 08:00 PM
Hello,
I tested your zip file. It worked with packet tracer 6.2. You need to wait a little bit after pinging.
I could ping both PCs from each other.
Masoud
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide