Routing

Hello community,I would like to know if it is possible to implement the PFRv3 technology without involving any branch site. Just allow HUB users to do load-balancing and MC path control router? thanks in advance

We are trying to establish eBGP multi hop but it is not working. HEre is the sample config. router bgp 1111 bgp log-neighbor-changesneighbor 208.110.23.246 remote-as 2222 neighbor 208.110.23.246 ebgp-multihop 5 neighbor 208.110.23.246 update-source ...

EIGRP key-id on cisco ASA's can only be between 0-255 , whereas it's much much higher on the Router's.  We are planning to implement EIGRP on cisco asa's to move away from static routing but realized that key-id on the router's is greater than 255 wh...

I have a internet connection through cox communications, for the past year or more I've had issues with packet loss sometimes it's around 10% and higher but for the most part it's about 1%. I've complained to them over and over and they tell me the i...

Hi, I am using Cisco 3560 switch as my core switch. Internet is terminating on the firewall (Cyberoam make). Firewall (LAN Port) is connected to 3560 switch and from here to edge switches. Now I need to MAC bind certain computers in the firewall. But...

Hello , Does any of the ISR 4000 routers support async Serial interface modules? I am looking to migrate a 2811 to 44xx. The 2811 is configured with NM-16A. I could not find an async module in the data sheets. I do see serial interfaces that support ...

Hi All, I connected to one of the routers via OOB and now i am stuck in this prompt, i cannot exit. or do ctrl + Z. Only way is to close and re launch -:- hostname cli->--:- hostname cli-> exit Error: Invalid command: exit--:- hostname cli-> exi...

Anybody have ATP document for Router & Switch

Picture attached. Objective: 1. ALL traffic from VLAN1 and VLAN2 in branch office to headquarters is routed via Dialer1. If dialer1 is not available then all traffic is routed via dialer2. 2. ALL traffic from VLAN1 and VLAN2 in branch office to the...

Network physically looks like this: CE1--PE1--P--PE2--CE2--C On device C is 172.26.70.0/24 I can ping this subnet from PE2, CE2 no problem. I cannot ping from PE1. PE1 is learning the subnet from PE2 via iBGP Subnet is appearing in the routing tab...