cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
642
Views
0
Helpful
1
Replies

Interconnect a router 1941 to fiber optic media converter

jeannzonzidi1
Level 1
Level 1

Hello,

I has a 1841 router connected in media converter rj45-optical fiber; the interfaces fastethernet have any errors :

FastEthernet0/0 is up, line protocol is up
Hardware is Gt96k FE, address is 9caf.ca71.9fb4 (bia 9caf.ca71.9fb4)
Description: LAN
Internet address is 172.16.243.42/30
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 2/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:08, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 839000 bits/sec, 76 packets/sec
5 minute output rate 23000 bits/sec, 42 packets/sec
16427382 packets input, 1627663670 bytes
Received 10604 broadcasts, 1097 runts, 0 giants, 0 throttles
106049 input errors, 106037 CRC, 0 frame, 6 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
9315298 packets output, 641397886 bytes, 0 underruns
0 output errors, 0 collisions, 6 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
FastEthernet0/1 is up, line protocol is up
Hardware is Gt96k FE, address is 9caf.ca71.9fb5 (bia 9caf.ca71.9fb5)
Description: WAN (10.140.0.14)
Internet address is 10.140.0.14/16
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 2/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 42000 bits/sec, 45 packets/sec
5 minute output rate 870000 bits/sec, 77 packets/sec
9314397 packets input, 1125438776 bytes
Received 16332 broadcasts, 58 runts, 0 giants, 0 throttles
1344 input errors, 1342 CRC, 0 frame, 1 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
16467493 packets output, 2495255891 bytes, 0 underruns
0 output errors, 0 collisions, 6 interface resets
5471 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out

i has changed the cable crossover in media converter, nothing change.

I want to change the router for a cisco 1941;

Help me, the router cisco 1941 can support to optical fiber link with 100 Mbps ?

1 Reply 1

saif musa
Level 4
Level 4

Hi,

Cisco router 1941 can support up to 1Gbps, also you trying to upgrade your router to the same router series so there is nothing to worry about.

Hope that helps

Regards

Review Cisco Networking for a $25 gift card