Internet protocol processing disabled

[Translator]

This question was published by @MERVINSLIMMONNET in another section, help us!

After adding a NIM-ES2-4 card to my router 4331 on packet tracer, I can't configure the interface because I'm told Internet protocol processing disabled when I make show ip interface of this interface.

I can't configure an ipv4 and ipv6 address on my interface

(after connecting the cable, the port is switched directly to green without shutdown)

Thank you!

[Translator]

Hello,

These are switched ports (module type ES2). Also, you need to configure a vlan on the port (like on a switch) and configure the IP on the corresponding VLAN interface.

See you soon