Hi Guys,
I am facing a tunnel issue.I am trying to create a tunnel 6to4 tunnel using ipv6.When i executes sh ip interface tunnel0 i see the destiantion is unknown.The confgs are written below with the troubleshooting part also.
Router 1
ipv6 unicast-routing
interface s0/1
ip address 30.0.0.1 255.0.0.0
clock rate 1200
no shutdown
interface tunnel0
ipv6 enable
ipv6 address 2002:c0a8:6301::1/64
tunnel source serial0/1
tunnel mode ipv6ip 6to4
no shutdown
ipv6 route 2002::/16 tunnel0
R4
ipv6 unicast-routing
interface s0/1
ip address 30.0.0.2 255.0.0.0
no shutdown
interface tunnel0
ipv6 enable
ipv6 address 2002:c0a8:6301::2/64
tunnel source serial0/1
tunnel mode ipv6ip 6to4
no shutdown
ipv6 route 2002::/16 tunnel0
***********************************************************
Error
IER1#sh interfaces tunne
IER1#sh interfaces tunnel 0
Tunnel0 is up, line protocol is up
Hardware is Tunnel
MTU 1514 bytes, BW 9 Kbit, DLY 500000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation TUNNEL, loopback not set
Keepalive not set
Tunnel source 30.0.0.1 (Serial0/1), destination UNKNOWN
Tunnel protocol/transport IPv6 6to4
Fast tunneling enabled
Tunnel transmit bandwidth 8000 (kbps)
Tunnel receive bandwidth 8000 (kbps)
Last input never, output 00:04:28, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
6 packets output, 552 bytes, 0 underruns
