IPv6 Multicast Replication Mode
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-01-2006 03:15 PM - edited 03-03-2019 11:37 AM
I got the following from Cisco Error Message Decoder.
Question: Does this mean "all" traffic will stop flowing, or just Multicast traffic? Or, just the module of concern?
. %MLSM-6-MMLS_MODE_CHANGE: MMLS: Replication Mode Change Detected
This message indicates that, when automatic detection of the replication mode is enabled, the system will transition to ingress mode when an egress-incapable module is inserted. The system will transition back to egress mode when the last egress-incapable module is removed.
Recommended Action: Transitioning between ingress and egress mode causes a temporary loss of traffic. To prevent this temporary loss of traffic, enter the mls ip replication-mode ingress command.
- Labels:
-
Other Routing
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-07-2006 07:56 AM
This condtion applies only for multicast traffic and this is a Multicast Distributed Shortcut Switching (MDSS)/multilayer switching for multicast (MLSM) messages.
