IR1101 SCADA

[Constantin S]

Hello everyone,

Has anyone here tried using the SCADA feature on the IR1101?
According to the documentation, it should be able to perform protocol conversion between IEC 60870-5-101 and IEC 60870-5-104 (in both directions).

I’ve been trying to configure an IR1101 router, but some of the commands mentioned in the manual are not recognized — for example, the “role” command under IEC101 or the “COT” command under IEC104.
I suspect that part of the procedure might have been copied from another platform or device.

I also tried configuring it based on the example provided in the documentation (omitting the unsupported commands), but I still can’t get the IR1101 to read an IEC-104 client through a 101 master connection.

Has anyone managed to get this working? Any tips or configuration examples would be greatly appreciated!

[pieterh]

when you mention "the manual" or "the document" you mean this?
 https://www.cisco.com/c/en/us/td/docs/routers/access/1101/software/configuration/guide/b-cisco-ir1101-scg/m-information-about-scada.html 
section: Configuring T101 and T104 Protocol Stacks?

[Constantin S]

Yes, that's the documentation I was mentioning. And I also tried to use the examples one on one and just adjust the project / test rig to work with it.

These are the commands wich didn't work:

T101:

Step 4 / role master / Assigns the master role to the T101 protocol channel (default).

T104:

Step 14 / cot size {one | two | three} / Defines the cause of transmission (cot), such as spontaneous or cyclic data schemes in octets.