06-11-2016 03:24 PM - edited 03-05-2019 04:12 AM
Hi We have a Nexus7000. but it cannot have any output of show ip arp in Nexus7000. I think that there is a command there to block it. Any one knows what it is? or what can cause this issue? I mean there are no any output when using the command--show ip arp in Nexus7000. Thank you
06-11-2016 07:36 PM
The question would be, are you learning an arp entry on the N7k. Try configuring an IP on two devices connected to the N7k switch and ping the devices from each other. You may then check to see if you are seeing an arp entry or not.
what modules do you have on the switch?
06-11-2016 08:15 PM
I found it in vrf interface. Thank you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide