03-13-2023 10:20 AM - edited 03-13-2023 10:22 AM
Is there a command for the ISR 4331 running 16.12.03 (Gibralter) to show an installed transceiver's wavelength?
I have an ISR 4331 with an SM-X-16G4M2X module installed. I am using DWDM optics in the 10G ports. I can get just about all the information for these interfaces except the wavelength:
Router# show hw-module subslot 1/0 transceiver 20 idprom
IDPROM for transceiver TenGigabitEthernet1/0/20:
Description = SFP or SFP+ optics (type 3)
Transceiver Type: = SFP+ 10GBASE-ER (276)
Product Identifier (PID) = XCVR-S80W34-IO
Vendor Revision = 01
Serial Number (SN) = V29W9W80
Vendor Name = INTEGRAOPTICS
Vendor OUI (IEEE company ID) = C8.DE.51 (13164113)
CLEI code =
Cisco part number =
Device State = Enabled.
Date code (yy/mm/dd) = 19/07/10
Connector type = LC.
Encoding = 64B/66B (6)
Nominal bitrate = (10500 Mbits/s)
Minimum bit rate as % of nominal bit rate = not specified
Maximum bit rate as % of nominal bit rate = not specified
Router# show hw-module subslot 1/0 transceiver 20 status
The Transceiver in slot 1 subslot 0 port 20 is enabled.
Module temperature = +29.906 C
Transceiver Tx supply voltage = 3309.1 mVolts
Transceiver Tx bias current = 40476 uAmps
Transceiver Tx power = 0.7 dBm
Transceiver Rx optical power = -18.4 dBm
Running "show interfaces" does not display the wavelength either, I'm afraid. Any help would be most appreciated. Thanks.
Solved! Go to Solution.
03-13-2023 11:30 AM
To answer my own question (and for anybody else who has the same question):
show hw-module subslot 1/0 transceiver 20 idprom detail
That produces a lot of useful output, but the zero in on the wavelength:
show hw-module subslot 1/0 transceiver 20 idprom detail | include wavelength
Router#show hw-module subslot 1/0 transceiver 20 idprom detail | i wavelength
Nominal laser wavelength = 1550 nm.
DWDM wavelength fraction = 1550.92 nm.
03-13-2023 11:30 AM
To answer my own question (and for anybody else who has the same question):
show hw-module subslot 1/0 transceiver 20 idprom detail
That produces a lot of useful output, but the zero in on the wavelength:
show hw-module subslot 1/0 transceiver 20 idprom detail | include wavelength
Router#show hw-module subslot 1/0 transceiver 20 idprom detail | i wavelength
Nominal laser wavelength = 1550 nm.
DWDM wavelength fraction = 1550.92 nm.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide