Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1070
Views
0
Helpful
1
Replies

jumbo frame

alsayed
Level 1
Level 1

‎12-06-2009 10:27 AM - edited ‎03-04-2019 06:53 AM

Hi

Lets talk MPLS,okay so how to let the switch deal with jumbo frame specially when u adjust the mtu size under the interface to 1512..

What is the command to do that?

v  Is it in global configuration [system mtu 1512]?

v  So what's happened to ospf tough?do I need to config under the interface the command: [ip ospf mtu-ignore]

Thanks

Labels:
0 Helpful
1 Reply 1

David Williams
Level 1
Level 1

‎12-06-2009 04:21 PM

Good day Alsayed,

The answer to your question is dependent upon what kind of hardware you are changing the MTU on.  Some switches allow interface level modification, while others require a system wide change, which often requires a reboot to take effect.  The link below has information about jumbo and giant frame support on different switching hardware.  I hope that helps.

http://www.cisco.com/en/US/products/hw/switches/ps700/products_configuration_example09186a008010edab.shtml

Dave

0 Helpful
Customers Also Viewed These Support Documents