Routing

I have a totally stubby area on one remote site router which I plan to integrate into a DMVPN network via DSL. Preferably, If my WAN link which is in Area 10 dies, the DMVPN tunnel act as a backup. Here's my problem, If I use backbone Area0 for the D...

while  i m trying to do write( save configuration on Routerfollowing error is displayedcannot communicate boot variable to standby

I am planning to upgrade from SUP720 to RSP720. I was looking for a step-by-step upgrade procedure document on CCO, no luck yet!Just wondering if there is any relevant document available for this!thanks,Fawad

Dear Experts,I am configuring OER and I learned various ways of measuring the traffic and set threshold like delay, Max-xmit, Max-range, Throughput etc.Is it possible to measure and change the traffic to another exit interface using the output queue ...

I'm trying to install a new internet connection from a different ISP.  In the process we are also getting a new external IP subnet.  I would like to be able to route traffic on the new subnet via the new connection and anything on the old IP subnet t...

Hi,router  Cisco 7206VXR (NPE-G2), ( which is configured as NTP master for all the core devices in network;) which  has problem a with its clock. The Router always falls behind its scheduled time even after re-configuring the clock number of times to...

Hello,1) If two different MST regions with instances MST0 MST1 and MST2 are interconnected, root bridge for MST1 and MST2 should be inside corresponding region. Shall root for MST 0 instance be only in one region on bridge with lowest priority? I kno...

Using the following code snippet:class-map match-any COS2  match access-group 181policy-map COS2_CLASSIFICATION  class COS2_TRAFFIC    police cir 552000 bc 69000 be 69000      conform-action set-dscp-transmit af31      exceed-action set-dscp-transmit...

I using isdn bri as our backup line. Below is the config on the dialer interface.If the 1st dialer string is fail to connect, how long is the time/dial-attempt taken before it using the 2nd dialer string to dial? interface Dialer1 ip address negotiat...

Can we configure UDLD on cisco ubr10000 ?Can someone help us which IOS version supports on cisco 10kMuch appreciated.. Thnx in advance

Hi,i have a wan router as shown   s1-----ospf------R1----eigrp-------s2.ospf is running on s1 interface and eigrp on s2 interface. i m learning many network from ospf domain ,but i m advertising  eigrp summary as default route(default route 0.0.0.0/0...

by use the cisco 7606.【Version 12.2(33)SRB5,Supervisor Engine 32 10GE】,when uset netflow collect the flow of app,and use snmp get the port traffic.but now,the flow of netflow not equal the traffic of snmp polling.why.under is the router's config:...