cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
422
Views
0
Helpful
2
Replies
cmadiam82
Beginner

Load Balance and Failover using EIGRP

Hi All,

We have this network (please refer to the attached file) which I want to configure loadbalance and failover on the remote site using EIGRP. How can this be done? Please note that links on the remote sites has different bandwidth.

Your help is much appreciated.

Regards,

cmadiam82

1 ACCEPTED SOLUTION

Accepted Solutions

Hi,

On the remote side router make sure the bandwidth and the delay commands should have the same value on both the wan interfaces.

I have tested on my GNS3, you can find attached the sample configuration for your reference.

Thanks

Karuppu

View solution in original post

2 REPLIES 2

Hi,

On the remote side router make sure the bandwidth and the delay commands should have the same value on both the wan interfaces.

I have tested on my GNS3, you can find attached the sample configuration for your reference.

Thanks

Karuppu

View solution in original post

Thanks a lot Karuppu!!!