Load balancing and binding
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-30-2005 04:17 PM - edited 03-03-2019 10:38 AM
We have a 6500 router with a CSM module for load balancing. Our current setup is to bind a subnet to a fiber port on the CSM. This was done to reduce the ability of spammers to abuse un configured subnets/ip's. Now we would like to add a non load balanced subnet to the same fiber port on the CSM. Basically we would like to have a switch with load balanced and non load balanced servers. However with our current setup this is not possible. Can this be done?
- Labels:
-
Other Routing
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-30-2005 04:55 PM
Cant you do multiple vlans (one for NLB and one for LB) and configure the fiber port as a trunk to receive traffic for both vlans ?
UC Solutions Architect
Pacific Northwest | CDW
CCIE Collaboration #17135 Emeritus
