11-30-2010 12:16 PM - edited 03-04-2019 10:37 AM
How do I configure the OSPF process to reflect the following metric calculations?
Bandwidth (Mbps) OSPF Cost
10000 2
10 2000
1.544 12953
0.768 26041
Thanx, Seth
11-30-2010 12:48 PM
You can apply the cost value directly to the interface. Cost is calculated on a hop by hop basis, and is generally additive, and you can't configure the cost-to-bandwidth numbers on a global basis ... must be done per interface.
int x/x
ip ospf cost x
Rob
11-30-2010 12:52 PM
Actually I think I figured it out.
If you use the "auto-cost referenced-bandwidth 200" command, this sets the global metric calculations.
Thanx, Seth
11-30-2010 01:00 PM
Ahh ... very nice ... my mistake.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide