I have to move AP's from a 5508 to an 8540. If I move the AP's via a DHCP option 43 change, will the AP's keep their names when the connect to the 8540 WLC?
I have a new 3504 WLC that I am using as my anchor controller with a 5520 as my foreign controller. The 5520 is using version 8.2 and the anchor controller is using version 8.10. The data path is coming up but the control path is not. I can eping ...
I am configuring a 1562I as a Mobility Express AP and when I am configuring the 5GHz radio I noticed that when configured for channel 36 my power options are levels 1 through 5. If I choose channel 157 the power level options are 1 through 7. Does a...
I have a warehouse with 3700 AP's all using only 5GHz with 2.4GHz disabled. In the warehouse we use both the MC3190 and MC32N0 scanners. I am getting a lot of complaints about network issues by users of the MC3190 scanners. When I run link tests t...
I have a 8540/HA WLC licensed for 4000 AP's with 2900 AP's all together connected. Today we installed 100 new 3802I AP's and all but about 20 are coming up on channel 36. The RF profile is configured for 40MHz channel bonding and we have all 5GHz ...
Thank you for the information but it still leaves some questions. For example, I assume that since I am using an internal antenna model that this would count as a "Triple Antenna" model. Then I would assume since I am not limiting any data rates th...
These do use Windows CE 6.0.
They have their minimum power at the default of -10dBm and I will set it to 8dBm as I noticed the signal levels are lower than I would like them to be. Most of the AP's are running at below 8dBm currently.
I am guess...
This location is out in the country with no nearby sources of interference that would affect the use DFS channels and the scan gun manufacturer says they support the use of all 5GHz channels. Isn't it better to have more channels to provide greater ...