Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1636
Views
5
Helpful
1
Replies

Need assistance configuring a second two port VWIC card

Jeff Wise
Level 1
Level 1

‎09-13-2010 11:19 AM - edited ‎03-04-2019 09:45 AM

I have a 2811 with two single T1 VWIC cards bonded together as a multilink. I installed a two port VWIC T-1 card and unable to configure, running configuration shows !card type command needed for slot/vwic-slot 0/2. When I try to configure the card type, I get the following message, Card in slot 2 was removed or does not support command. Show diag shows WIC Slot 2: VWIC2-2MFT.

Help please.

Thanks

Labels:
0 Helpful
1 Reply 1

Jeff Wise
Level 1
Level 1

‎09-13-2010 01:34 PM

Think I got it, used the following command, card type T1 0 2

Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card