cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
315
Views
0
Helpful
3
Replies

Need help on BGP where on one of the interfaces,RX is not happening

sravan2211
Level 1
Level 1

Need help on BGP where seconday router interfaces,RX is not happening.Site has two MPLS links which are in active active mode, but on one of the router Rx load is not happening.Please advice

 

 

sh int g0/0 on primary link

 

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 3722000 bits/sec, 425 packets/sec
  5 minute output rate 417000 bits/sec, 185 packets/sec
     8409482 packets input, 2698974461 bytes, 0 no buffer
     Received 1914 broadcasts (0 IP multicasts)
     0 runts, 0 giants, 0 throttles
 

sh int g0/0 interface on secondary link

 

 

MTU 1500 bytes, BW 4000 Kbit/sec, DLY 100 usec,
     reliability 255/255, txload 42/255, rxload 1/255
  Encapsulation 802.1Q Virtual LAN, Vlan ID  1., loopback not set
  Keepalive set (10 sec)
  Half Duplex, 100Mbps, media type is RJ45
  output flow-control is unsupported, input flow-control is unsupported
 

 Last input 00:00:05, output 00:00:00, output hang never
  Last clearing of "show interface" counters 1w0d
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 668000 bits/sec, 164 packets/sec
     145223862 packets input, 553678799 bytes, 0 no buffer
     Received 535 broadcasts (0 IP multicasts)
     0 runts, 0 giants, 0 throttles
 

3 Replies 3

Ruben Cocheno
Spotlight
Spotlight

Do you see packets input increasing? If you have LDP adj over that interface can be a cosmetic issue (sounds strange, but...) That interface is in Half Duplex, i would fix forcing it too.

Tag me to follow up.
Please mark it as Helpful and/or Solution Accepted if that is the case. Thanks for making Engineering easy again.
Connect with me for more on Linkedin https://www.linkedin.com/in/rubencocheno/

Yes,I can see the packets increasing on input and output of the interface of the secondary link.

 

The primary having the Full duplex and the secondary having the half-duplex. - will this need to be changed? please advice.

 

 

 

 

 

 

Hi,

Auto-nego is not working properly because of a fault cable or different vendors on each side, i would force it to 1000-full

Tag me to follow up.
Please mark it as Helpful and/or Solution Accepted if that is the case. Thanks for making Engineering easy again.
Connect with me for more on Linkedin https://www.linkedin.com/in/rubencocheno/
Review Cisco Networking for a $25 gift card