cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
265
Views
0
Helpful
1
Replies

Need multicast help

millerlw
Level 1
Level 1

Hi,

I am having trouble getting some multicast traffic across a link.  I have a 3750G setup, with IP routing and IP multicast routing, between two laptops.  This will eventually sit between two networks that cannot be physically connected to each other for security reasons.  I have static joins on the ports but cannot see the multicast traffic on the receiver.  I am attaching the latest config.  The sender(10.10.4.2) sits on gi1/0/24 and the receiver(10.10.3.2) sits on gi1/0/1.  I am using VLC to test this and it will connect if I point the receiver to the address of the sender, but will not receive any multicasts.  The multicast traffic is not making it to the 10.10.3 side, I used wireshark to verify that it was not making it across.

Any help would be appreciated.


Thanks,

Leonard

1 Reply 1

millerlw
Level 1
Level 1

This has been fixed

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card