Needed Help
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-26-2023 04:36 AM
In this topology Routers are configured as given in the diagram
Routing Protocols used,
B/W R0, R10, R7 ospf
i have configured tap4 using iptables to nat and forward the traffic to my physical network adapter, which is connected to internet.
my question is when i ping R11 (i.e IP - 14.14.1.3) from the ubuntu machine it was unreachable, why?
Thanks in advance for the reply
- Labels:
-
Routing Protocols
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-26-2023 04:42 AM
and other router. are you config static route ? if not you need to config default static route or OSPF between all router
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-26-2023 04:49 AM
Forgot to mentioned that, i had already configured static NAT between other routers.
internally i can able to ping all the routers in topology ( i.e from R0 to R11, R12 to R9, etc.) but when i try to ping 14.14.1.3 from my ubuntu machine it was unreachable
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-26-2023 08:52 PM
Hello
@ashz14387 wrote:
Forgot to mentioned that, i had already configured static NAT between other routers.
internally i can able to ping all the routers in topology ( i.e from R0 to R11, R12 to R9, etc.) but when i try to ping 14.14.1.3 from my ubuntu machine it was unreachable
So you have NAT running on all 3 rtrs (rtr0-7-11) and Tap4 is external to the rest of the network , if so do you have a nat statement for the external hosts to reach 14.14.1.3
Can you share the configuration of the rtrs please?
Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.
Kind Regards
Paul
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-26-2023 04:53 AM - edited 05-26-2023 04:59 AM
for ubuntu it see mapped IP and it reachable
but for R11 it must know how it can reachable ubuntu, you need static route in R11 point to R10
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-26-2023 04:53 AM - edited 05-26-2023 04:54 AM
Hi
If your Ubuntu is using IP address 168.224.1.x, the only thing you need to add this network to the OSPF on R0.
But, if you are ping from another interface (network) from Ubuntu, you need to add a static route in R0, pointing to Ubuntu and add the command "redistribute static subnets" on the OSPF.
