I try to work the netfow on my router 881 with ios 15.0.1 but when t put rhis command
BOA_SDSL#sh ip flow top-talkers % Cache is empty
Here the output of command
BOA_SDSL#sh ip flow interface FastEthernet4 ip route-cache flow ip flow ingress Vlan1 ip route-cache flow ip flow ingress
interface FastEthernet4 ip address xxxxxxxxxxxxxxxxxxxxxxxxxx ip flow ingress ip nat outside ip virtual-reassembly no ip route-cache cef duplex auto speed auto no cdp enable crypto map clientmap hold-queue 100 out
interface Vlan1 description $ETH-SW-LAUNCH$$INTF-INFO-HWIC 4ESW$ ip address 192.168.1.252 255.255.255.0 ip flow ingress ip nat inside ip virtual-reassembly no ip route-cache cef ip tcp adjust-mss 1452 standby use-bia standby 1 ip 192.168.1.254 standby 1 priority 105 standby 1 preempt delay minimum 60 standby 1 track 1 decrement 10 hold-queue 32 in hold-queue 100 out
ip flow-top-talkers top 10 sort-by bytes
With this confguration the netfow works fine ion a 871 router
Hello!I'm looking for a way to make my EEM script more dynamic and automated for my environment. This is what I have - basically I just capture the 4 IPSec peer IP addresses of each neighbor and insert this data into 4 different variables. ...
Hi all,I have a couple of Nexus9k switches. I need to get tcpdump from the physical interface which connected to the server. I'm looking for a specific protocol on tcpdump so that which feature should I use? I asked that because I couldn't full...
We are building out our first few AAR polices and are running into an error message.Built Global Policy with SLA class and traffic rules for voice traffic, attached to to the sites and VPN we needed, no issue. Building a second policy for management ...
Cisco Champion Radio · S7|E45 Network Insights with AI Endpoint Analytics
Identifying who and what is on the network is a challenge for many organizations. Incomplete visibility makes it difficult to implement advanced security policies and recommendatio...
HI, In the attached diagram from cisco site if we assume R101 and R102 are two DC having a layer 2 link and both are advertising same subnet (eg. 192.168.12.0/24) to the ISP i understand by using BGP metrics we can make one DC primary and other as se...