Networking Project Help

[daniel_growth]

Hi All,

Below is a picture of my topology,

The file to the packet tracer is also attached. All password or logins are admin and cisco.

I would like DEV and Management network traffic to route through the firewall when access the corp network.

I have yet to configure the router and firewall as i'm not sure in what to do. 

My other question is VLAN 10 and 20 can not cross communicate. This is the way i want it, but should i also put ACLS to reinforce this rule as best practice?

Kind Regards,

Daniel!

[daniel_growth]

Also S4 to S1 is painfully slow. I have checked my RAM and it is not hardware related. This must be the way the devices are configured.
Switch>en
Switch#ping 10.10.10.1

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.10.10.1, timeout is 2 seconds:
..!!!.
Success rate is 60 percent (3/5), round-trip min/avg/max = 483/791/946 ms

[Georg Pauwen]

Hello,

the problem is that interfaces GigabitEthernet1/2 and 1/3 are both configured with the sane address space. A 'real' ASA would not let you do that. It causes OSPF to form an adjacency with S2, which is in 'standby' state. Shut down the interface:

interface GigabitEthernet1/3

shut

[daniel_growth]

No luck.

Switch#ping 192.168.1.1

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.1, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)

[Georg Pauwen]

Hello,

so from S1 you are able to ping 10.10.15.20 and 10.10.15.21 ?

[daniel_growth]

Yes that is successful. I can do that from S4 also.

[daniel_growth]

@Georg Pauwen 

I will attach my newest file. I am struggling with pinging to the 172 address from the switches and back.

TACACS/Radius will not seem to work on switches

HSRP standby IP's are complaining

The firewall needs the G1/2-3 interfaces fixing.

If you could help id really appreciate it.