Newb for ASR9k module instalation

[Hisoma Sama]

Hello team

I'm supposed to install some modules for ASR 9k and I'm looking for any installation guide for anyone who have done this before.

what I'm gonna install as per BOM below

A9K-RSP880-SE= ,   A9K-MPA-20X1GE= ,  A9K-MPA-4X10GE=  ,  A9K-MPA-2X10GE=  ,  ASR-9010-FAN-V2=  ,  XFP-10G-MM-SR=  , XFP10GLR-192SR-L ,   A9K-MOD200-TR=  ,  A9K-MPA-FILR  , 

and since the device ASR9k is up and running whats the steps for installation and is there any configuration involved 

and thanks in advance

[marce1000]

 https://www.cisco.com/c/en/us/td/docs/iosxr/asr9000/hardware-install/hig/b-asr9k-hardware-installation-guide/b-asr9k-hardware-installation-guide_chapter_011.html

 M.

[Hisoma Sama]

thanks marce1000 for your quick reply

is it the same procedure either the device was up or down?

[Georg Pauwen]

Hello,

on a side note, I don't think you need power down the device:

Online Insertion and Removal
Most Cisco ASR 9000 Series Routers FRUs can be removed and replaced with the power on and the system operating. This is known as online insertion and removal (OIR). Power modules, fan trays, Route Switch Processor (RSP) cards, Route Processor (RP) cards, Fabric Controller (FC) cards, Line Cards (LCs), shared port adapter (SPA), and SPA interface processor (SIP) cards all support OIR. Unless otherwise noted, the maintenance tasks described in this chapter can be performed while the router remains powered on.

https://www.cisco.com/c/en/us/td/docs/iosxr/asr9000/hardware-install/hig/b-asr9k-hardware-installation-guide/b-asr9k-hardware-installation-guide_chapter_0101.html#con_1270304