hi guys, i have router that is connected to 2 ISP's, the link to ISP1 is of 786 and that of ISP2 is 1 mb, due to some constraints we want the link to ISP1 to be primary and ISP2 to be backup, now normally it happens that there is some internal problem in ISP1 and the internet is not working while the interface status remains UP!!, so now we cant easily shift to the other link since the primary link never physically goes down !! to solve this problem i know we can use OER but its posing 2 problems
1) in OER as far as i know we cannot determine our primary link, OER will judge itself which link to use and install static routers for it so we cant define our primary link
2) if any of the participating interface goes down OER doesnt work since atleast 2 interfaces are required for it..
I planned to use object tracking with this in mind
define 2 default routes with the one with ISP with greater AD. now the object will track a particular prefix and in case if its down it will not install the primary default route and hence we will shift to the other route.
now the router is 3845 and rtr commands doesnt work anymore, a guy mentioned SLA but honestly i am not able to put it into work can some1 give me a sample configuration as to how to use it to solve my problem since this a very common issue for any organization, if there is some completely different soultion then kindly tell me
plz remember that i cannot run BGP with any of the ISP they have refused to do it
Currently when changing the Authentication Template under the Onboarding section, there is no choice but to remove SGTs, VNs and IP Pools which clearly disrupt existing services.
Hitless Authentication was introduced in...
Hi, I want to redistribute OMP routes to BGP, i have the doubt if all of the OMP prefixes located in the local vEdge will be redistributed to BGP or just the connected+static networks located in the vEdge. Also how can i restrict some OMP prefix...
Let's say we have two routers configured as RP candidates for auto-RP: R1 - "advertising" its loopback0 interface IP address 18.104.22.168 as the RP for these groups:22.214.171.124/32126.96.36.199/32188.8.131.52/24184.108.40.206/16 R2 - "advertising" its loopback0 int...
hi,i just performed an IOS upgrade and got a report that admin can't create L2 VLANs.i noticed the 'vtp primary force' and 'vtp primary mst' was applied to one of the core switch and perhaps got lost after the upgrade.how to keep the VTP primary persisten...