03-10-2009 06:06 AM - edited 03-04-2019 03:52 AM
7609(config)# int mul 11
7609(config-if)#ip load-sharing
7609(config-if)#ip load-sharing ?
per-destination Deterministic distribution
7609-2(config-if)#ip load-sharing
------
> The card is STM1/OC3 with SFP modules in it
> dCEF is enabled,
> is there any hidden command or any software bug, i am using 12.2(33)SRA5 or suggest IOS which supports this
------
the following command is also not available
Globalconfig#hw-module slot <no> per-packet
it is very urgent kindly help me out
03-10-2009 06:27 AM
ip load-sharing is used under the physical interface.
With a multi link you are already load sharing with the circuits that are bundled.
03-10-2009 06:31 AM
the same is working fine(on Multilink) in 7206 router. But
the physical interface on 7609 also is displaying the same (per-packet is not seen)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide