Opening firewall, Incoming and Outgoing for one IP Address - RV180

[Len Levin]

I have a RV180 that I want to open the firewall, both incoming and outgoing for one IP Address.  The IP address is a reserved address, assigned by MAC address for a AT&T microcell.

The RV180 is connected to Cox Cable modem.  The cable modem is in bridge/passthrough mode.

On the Inbound rule, I can't specify the LAN IP address. On the Outbound rule It appears i can set both IP addresses.

What am I missing?

Thanks.

Len

[Georg Pauwen · Accepted solution]

Hello,

for the inbound rule, you have to use the 'Send to Local Server (DNAT IP) field to specify the LAN address. Check page 82 (Step 7) of the attached admin guide:

http://www.cisco.com/c/dam/en/us/td/docs/routers/csbr/rv180w/administration/guide/rv180w_admin.pdf

[Len Levin]

Georg,

Thanks for the response.

I thought that was the place for the address, but I wasn't sure.  Thanks for confirming it for me.

Len