Routing

We are testing a EoMPLS VC type 5 / Ethernet vc in our lab on VSS setup and not able to pass traffic.  The VSS is Sup2T (15 + code) and we have a single AC connected to switch 2 of the VSS.. with switch 1 currently having the active sup in the system...

This question regards whether or not I have to upgrade the firmware on an ASR1006 device, when upgrading IOS version. Device is currently running IOS XE - 03.04.05.S (Version 15.1(3)S5) - asr1000rp1-advipservicesk9.03.04.05.S.151-3.S5.bin I am upgrad...

The Internet is full of articles advising that NetFlow v5 does not support 'ip flow egress' but I think this must be incorrect or outdated? I have configured a Cisco 7200 with only 'ip flow egress' enabled (on WAN) with NetFlow version 5 and the flow...

Hi, In my cisco 1841 router the below logs came contionously. Can u anyone tell me the solution.LOG:*Aug 16 10:08:23.800 India: %GT96K_FE-5-LATECOLL: Late Collision on int  FastEthernet0/1*Aug 16 10:08:24.048 India: %GT96K_FE-5-LATECOLL: Late Collisi...

We have up to 60 users in our office. We got internet from ISP with fiber using EPON(act like bridge). We have a rack with 24 punch-panels with cable ports around the wall. How can i distribute internet to users with all ports installed around the wa...

Hi, We are trying to connect a Cisco router 4300 to a CenturyLink C1100z modem, we've tried every possible configuration but cannot establish a connection to the modem from the cisco router via Static mode. but the router will connect through Bridge...

Dear Friends, I have a Cisco 1841 with 1 WAN connection (ATT) receiving a Public IP Addresses /29 and we have a static NAT to map it to private IP Addresses and we are using Dynamic DNS to use a name instead of IP Address to connect to this site (I ...

Hi all, We have 3 subnets Outside: 203.0.0.0 (GigabitEthernet0/0) DMZ: 172.16.1.0 (GigabitEthernet0/1) Inside 192.168.10.0 (GigabitEthernet0/2) Currently DMZ and Inside go out to separate Layer 2 switches. Which means all  DMZ to Internal bottlene...

Hi - I need help in troubleshooting EIGRP flapping issues on HUB. Hub = CISCO3945 ( with VPN Module ) Hub has over 40 spoke sites running EIGRP over tunnel. Some of the EIGRP neighbors are constantly flapping and some are up and running fine There is...