Password recovery on ASR 1006

[Amos Kafwembe]

Hi all,

I am trying to perform a password recovery on a Cisco ASR 1006, I can ctrl + break and set the register to 0x2142, i then power cycle it, but it keeps booting back into the 0x2102 register. is there anything different about this device?

[Leo Laohoo]

Some smart a$$ must've enabled "no password-recovery".  Can you inspect the appliance and see if there is a tiny "RESET" button available? 

If there is none, then you need to read (carefully) THIS.

[Amos Kafwembe]

Hi,

thanks, though this procedure is what worked;

http://www.networking-guru.net/2011/04/asr1006-dual-route-processors-password_6168.html