cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
8426
Views
0
Helpful
3
Replies

Password recovery on ASR 1006

Amos Kafwembe
Level 1
Level 1

Hi all,

I am trying to perform a password recovery on a Cisco ASR 1006, I can ctrl + break and set the register to 0x2142, i then power cycle it, but it keeps booting back into the 0x2102 register. is there anything different about this device?

3 Replies 3

Leo Laohoo
Hall of Fame
Hall of Fame

Some smart a$$ must've enabled "no password-recovery".  Can you inspect the appliance and see if there is a tiny "RESET" button available? 

If there is none, then you need to read (carefully) THIS.

Hi,

thanks, though this procedure is what worked;

http://www.networking-guru.net/2011/04/asr1006-dual-route-processors-password_6168.html

wangzixiong
Level 1
Level 1

This problem should be redundant routing engine. Pull one engine out and try again would be solve this problem.

Review Cisco Networking for a $25 gift card