Hello Guys,
I'm having this problem with a Cisco device:
The interface
Interface Vlan3 "dmz", is up, line protocol is up
Hardware is EtherSVI, BW 100 Mbps, DLY 100 usec
MAC address 0007.7da7.54d6, MTU 1500
IP address 10.40.18.8, subnet mask 255.255.255.224
The route
S 10.198.0.0 255.255.0.0 [1/0] via 10.40.18.1, dmz
The ping
ping 10.40.18.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.40.18.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/10 ms
ciscoasa# ping 10.40.18.9
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.40.18.9, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
ping 10.198.36.100
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.198.36.100, timeout is 2 seconds:
?????
Success rate is 0 percent (0/5)
traceroute 10.198.36.100
Type escape sequence to abort.
Tracing the route to 10.198.36.100
- 10.40.18.1 0 msec 0 msec 0 msec
The traffic is sent to Kyndryl device (I guess), but we’ve got no reply.
