09-07-2006 07:12 AM - edited 03-03-2019 01:54 PM
Hi;
we have two routers connected directly to each other through E1 link, first router is 2811 router and the second one is 7200 router.
since 2811 router as I know, is not supporting pppoe server only client; so we need to terminate whatever pppoe packates coming via the fa of the 2811 router in the fa of the 7200 router.
To do this so; I have configured L2TPv3 in the two router and Xconnect in the fa of each router.
the L2TPv3 tunnel is up and established but the pppoe traffic is not being sent to the 7200 router or may be it is sent but not terminated.
Regards,
aalhousani
Solved! Go to Solution.
09-20-2006 09:34 PM
Sure find below is the pppoe configureation (it is configured only in the 7200 router).
vpdn enable
!
vpdn-group 1
!
bba-group pppoe global
virtual-template 1
!
interface Ethernet3/3.1
encapsulation dot1Q 100
pppoe enable group global
!
interface Virtual-Template1
mtu 1492
ip address 200.164.200.129 255.255.255.128
peer default ip address pool Test
ppp authentication pap
!
ip local pool Test 200.164.200.130 200.164.200.140
Note the following:-
1) under the vpdn-group (dialin), I can't configure protocol pppoe.
2) It is not possible to configure prorocol pppoe under the subinterface.
3) Yes it was working when configered in the main interface but when also the L2TPv3 is configured in the main interface.
4) regarding creating seperate bba group, I don't try it.
Thanks.
09-23-2006 01:48 PM
Hello,
Did you think the IOS maybe cuasing this issue? where I am running 12.4(10) in the router.
Refrence to the link you posted; the pppoe was configured under the vpdn-group where in this IOS pppoe is configured under bba-group!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide