If you traceroute stop on the first hop that does not necessarily mean that packet also stops there. Traceroute is UDP and rely on ICMP unreachable's sent from each hop. If UDP is blocked or no ip unreachables configured on the further hop - then you will not see any traceroute reply. SO this is not reliable test.
So you have your DNS resolved - good. Now keep in mind that connection to Internet is not only traffic forwarded to Internet but also traffic being sent from Internet to your source address and you need to check that both flows are working.
First check the forward traffic - see if your router has a correct route/default route to Internet ip address. Then make sure you have correct NAT on your router.
Basically you can configure router to do Policy Based Routing - to send particular traffic to the next hop which you explicitly specify - in that way outer will not rely on it's routing table. But this will depend on the router model.
Configs and show commands may help to look at your problem deeper.
Hitless Authentication was introduced in Cisco DNA Center 184.108.40.206 providing the ability to modify the Authentication Template under "Host Onboarding" without the need to remove SGTs, VNs, and IP Pools and therefore avoi...
Hi, I want to redistribute OMP routes to BGP, i have the doubt if all of the OMP prefixes located in the local vEdge will be redistributed to BGP or just the connected+static networks located in the vEdge. Also how can i restrict some OMP prefix...
Let's say we have two routers configured as RP candidates for auto-RP: R1 - "advertising" its loopback0 interface IP address 220.127.116.11 as the RP for these groups:18.104.22.168/3222.214.171.124/32126.96.36.199/24188.8.131.52/16 R2 - "advertising" its loopback0 int...
hi,i just performed an IOS upgrade and got a report that admin can't create L2 VLANs.i noticed the 'vtp primary force' and 'vtp primary mst' was applied to one of the core switch and perhaps got lost after the upgrade.how to keep the VTP primary persisten...