Same subnet address to ethernet interfaces of a router

[ashishrohilla]

Hi

I want to assign same subnet addresses to two ethernet interfaces of a router, default behavior of a router doesnt allow it but i am sure there might be some way around.

As i have three routers and dont have any hub or switch and want to do some lab where in two routers are connected to 3rd one through ethernet on the same segment. Pls help

Thanks in advance.

AR

[rais.ahmad]

This will require bridging to be enabled on the router.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1818/products_configuration_guide_chapter09186a0080087907.html

Hope this addresses your need.