cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
646
Views
0
Helpful
1
Replies

Soft Loop on interface

Mosiur Rahman
Beginner
Beginner

Hi All,


I am a beginner in networking.


Is there a way to perform a soft loop on ethernet interface on router for testing RFC2544 with a tester?

1 Accepted Solution

Accepted Solutions

balaji.bandi
VIP Guru VIP Guru
VIP Guru

Not sure what is the objective here. - i did Long Long ago as i remember, not sure the outcome.

 

To create a loopback plug, cross pin 1 (TX+) and pin 3 (RX+) together, and cross pin 2 (TX-) and pin 6 (RX-) together

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

1 Reply 1

balaji.bandi
VIP Guru VIP Guru
VIP Guru

Not sure what is the objective here. - i did Long Long ago as i remember, not sure the outcome.

 

To create a loopback plug, cross pin 1 (TX+) and pin 3 (RX+) together, and cross pin 2 (TX-) and pin 6 (RX-) together

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers