Hello All, I have cisco 2600 series it has ADSL Port, I used to have PPPOE connection and dynamic IP with my provider I had username and password it was working fine, but now I bought a static IP from them, they are telling me you don't need username and password just assign the Static IP to your ATM0/0 port and default routing that is all, but I doubt that because I have to use PPP encapsulation so I have to have PPP either pap or chap authentication it should be like this
interface Dialer1
ip address negotiated
ip mtu 1492
ip nat outside
ip virtual-reassembly
encapsulation ppp
dialer pool 1
ppp authentication pap callin
ppp pap sent-username XXXX@XXX password 0 XXXXX
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
so now, what parameters I should get from them to get this working? is what they are saying right? even I did with no luck.