cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
907
Views
5
Helpful
2
Replies

switch command (CLI) to show the ip address range

I need the switch command (Nexus) to show the ip address range assigned to each vlan on the network. For example Staff_vlan 100 what are the valid ip address for this vlan?

2 Replies 2

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

You can view show run interface vlan x ( it will show you subnet mask assigned to that VLAN) - that is the range for VLAN (is that works for you )

 

you can also show ip arp all | in vlanX will give you what is active ? - if this nexus is Layer 3 for this vlan.

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

here is the cisco example

shvlan.PNG

There are worlds out there where the sky is burning, where the sea's asleep and the rivers dream, people made of smoke and cities made of song. Somewhere there's danger, somewhere there's injustice and somewhere else the tea is getting cold" Dr Who
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers