Telnet using source IP address

[snarayanaraju]

Dear Experts,

Is there any way I can TELNET using the source IP address. I am aware of the

command

telnet 192.168.1.1 /source-interface fastethernet 0

But Here in this command I am able to specify only the Interface and not the

IP Address. Why i raised this point is, I am trying to TELNET a remote host

using my secondary IP address of the Interface.

Thanks in advance

sairam

[Richard Burts]

sairam

I am not aware of any way in IOS to telnet and to source the telnet packets from a secondary address. When an IOS router generates a packet (including generating a telnet packet) the default is to use the primary address as the source and I am not aware of any way to change this behavior.

HTH

Rick

[snarayanaraju]

Hi Rick,

Thanks. recently i surfed a Blog site and got the workaround for source telnet. But he didnt said how to do.He has shown only the solution. Please refer the link below

http://blog.zakir.net/index.php?/archives/44-Router-Tricks-Sourcing-telnet-from-secondary-IP-address.html

Hope it will give some clues. Please suggest how it works

sairam

[snarayanaraju]

Hi,

Had anybody seen the link. can you please shed some light on this

sairam

[somsh · Accepted solution]

hi mate,

It is possible , try this command

telnet 10.10.10.1 /source-interface fastEthernet 0/1 /route:(Ip )

Cheers

Som

[snarayanaraju]

Hi,

Have you gone thru the link. I am not able to understand or interpret the way he made the ACL to do Source TELNET

Thanks in advance

sairam