Hello - I need help to get a script for Deploying Static EPG in VPC interface. The equivalent CLI configuration is below   vpc context leaf 2471 2481   interface vpc VPC-TO-APPSERVER   switchport trunk allowed vlan 200 tenant PROD application AP_SERVER epg EPG_DMZ_VLAN200_SERVER   switchport trunk allowed vlan 201 tenant PROD application AP_SERVER epg EPG_DMZ_VLAN201_SERVER   exit   This is my learning, but I am not able to get the right script for deploying the EPG in VPC. I have around 200 lines of CLI commands to achieve this. 1) I tried to download the xml file (configuration only) in the path Tenant--> PROD--> Application Profiles-->AP_SERVER->EPG_DMZ_VLAN200_SERVER. The output has only a line of XML header. 2) arya.py -f <filename>.xml -i 10.100.206.1 -u <credentials> to get the cobra scripts   regards,Sairam ... View more

Hello - It is a general question to know how to determine the model of the Router based on the WAN Internet link i am going to connect.    Reading the article http://www.anticisco.ru/pubs/ISR_G2_Perfomance.pdf and other datasheet it is mentioned about the "Throughput" of the Router.   This throughput is the forwarding capacity of the backplane of the Router? If the Interface of the Router is supported 1 Gbps why any Router cannot have the WAN link maximum to 1Gbps?   For example, i have 2911 Router having 10Mbps Link, We are going to upgrade the link to 200Mbps. Want to know if this router supports this WAN link. I have different category of traffic like Voice, Data, QoS, BGP on Internet link   Can you help me please   regards,Sairam ... View more

Thanks all for sharing ideas, expertise solutions and answer. I need a help   We are planning to migrate Point to Point GRE tunnels to DMVPN or MGRE tunnels where Datacenter(Hub) router will have one tunnel and remote sites will have GRE tunnel to my Hub Router.   I current situation we have the flexibility of shutting down a GRE Tunnel of a remote site (Example: Chicago Office) from Hub itself by getting into the respective tunnel of Chicago and give command "shutdown" and later by "no shutdown" I can bring up the site. This requirement arises during troubleshooting    What is the way I can shutdown a remote office Tunnel from Hub Router if I migrate to DMVPN or mGRE tunnel?   regards,Sairam ... View more

Hello All - Refer the diagram attached. What is the advantage or requirement of configuring iBGP session between Router 1 and Router 2.   I am learning prefix 10.1.0.0/16 in R1 using eBGP between R1 and R3 I am learning prefix 10.1.0.0/16 in R2 using eBGP between R4 and R2 Using network command in R1 and R2, advertising 192.168.1.0/24 to R3 & R4 respectively EIGRP between R1 and LAN L3 Switch. Redistribute BGP to EIGRP EIGRP between R2 and LAN L3 Switch.  Redistribute BGP to EIGRP   regards,SAIRAM ... View more