Traffic Shape Rate

[Raghavendra Bandaru]

Please provide a detailed explanation of the below command used in Frame relay circuit.

interface Serial0/1/0
mtu 2044
bandwidth 1984000
no ip address
no ip proxy-arp
encapsulation frame-relay IETF
no fair-queue
frame-relay lmi-type ansi

!

interface Serial0/1/0.21 point-to-point

bandwidth 128000

ip address 10.2.255.13 255.255.255.252

traffic-shape rate 256000 128000 128000 1000

traffic-shape adaptive 128000

[paul driver]

Hello

This is Generic Traffic shaping  - GTS

AsI understand it, what you have posted is telling Serial0/1/0.21 to:

Rate all traffic at 256Kps and in case of congestion dont fall below 128kps ( adaptive)

res

Paul

Please don't forget to rate any posts that have been helpful.

Thanks.

[Joseph W. Doherty]

Disclaimer

The   Author of this posting offers the information contained within this   posting without consideration and with the reader's understanding that   there's no implied or expressed suitability or fitness for any purpose.   Information provided is for informational purposes only and should not   be construed as rendering professional advice of any kind. Usage of  this  posting's information is solely at reader's own risk.

Liability Disclaimer

In   no event shall Author be liable for any damages whatsoever (including,   without limitation, damages for loss of use, data or profit) arising  out  of the use or inability to use the posting's information even if  Author  has been advised of the possibility of such damage.

Posting

You've looked up the command in the command reference and configuration guide?  If so, what additional explanation are you seeking?  I.e. what don't you understand?