Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
what does the below statement mean in a WLC CT5760 sh version output. Please explain.
Configuration register is 0x201 (will be 0x102 at next reload)
Thanks
Raghavendra
Hello,
what does the below statement mean in a WLC CT5760 sh version output. Please explain.
Configuration register is 0x201 (will be 0x102 at next reload)
Thanks
Raghavendra
Can anyone confirm, if we have HREAP support on WLC CT5760, if yes, is their any design guide, if doesn't support, any alternate solution to get HREAP connectivity with AP's located at a different site and WLC at datacenter and having local switching...
Please provide a detailed explanation of the below command used in Frame relay circuit.interface Serial0/1/0mtu 2044bandwidth 1984000no ip addressno ip proxy-arpencapsulation frame-relay IETFno fair-queueframe-relay lmi-type ansi!interface Serial0/1/...
Hi Rasika,Thank you so much for that response, Can you please also help on how to design the mobility group for this setup. we are trying to connect both WLC5760's with stack cable and have redundancy, but how should we create a mobility group.My dou...
Hi Rasika,If 5760 model WLC does not support Hreap, can we create subnets of remote site in WLC located at datacenter and make it work as normal local switching over WAN ? latency from datacenter to remote site is approximately 60ms. if users use wir...
you do not have any IP address assigned to vlan 2 on 2960 switch, what ip you are trying to ping from 3560 to 2960 ? moreover, your default route is pointing to 192.168.8.1, where is 192.168.8.1 configured ? ThanksRaghavendra Bandaru" Rate this, if i...
Hi Rasika, Thanks for the confirmation, In our design, WLC is in data center and serving clients at other sites, any possibility to get this worked with CT5760 model WLC ? ThanksRaghav
