09-28-2018 09:21 AM
Hi,
I have 2 ISP connections, one with 10 Mbps and another 10 Mbps.
I want two links to work together simultaneously two 10 Mbps link in one Nat network of 192.168.1.0/24
I have a Cisco router 2911(3 Interfaces only)
in inside how to achieve this
like i will use one ISP traffic for voice
another ISP traffic for data and use class c address 192.168.1.0/24
in this half of the hosts means 128 hosts for data and remaining for voice.
How i can configure the router to achieve this ?
please help anyone.
no protocols or other is used.
like below topology
Can anyone help me ?
09-28-2018 10:57 AM
Hello,
have a look at the link below, it uses PBR and also a failover mechanism in case one of your links goes down. If you get stuck, post the full config of your router so we can fill in the necessary bits and pieces...
09-28-2018 09:16 PM
hi thanks for reply
actually my target is at a time voice traffic goes to 100 users and data goes to another 100 users
it is possible
i am using using sub netted IP like 192.168.1.0/25 and 192.168.1.128/25 is possible?
192.168.11.0 to 192.168.1.127 =voice traffic
192.168.1.128-192.168.1.254=data traffic
it is possible to configure single inside interface using pat
please tell me
09-28-2018 09:38 PM
09-29-2018 12:41 AM
Hello,
your access lists have to match the ports used for voice. Post the configuration of your router...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide