802.1Q y LACP in Router 8300 - SD WAN

[fs_santosc1]

Hello, I would like to ask if it is possible to configure 802.1Q on a portchannel. I attached an image of the topology. I would like to use the Po1.100 interface as a service VPN and the Po1.200, Po1.300 interface as a transport VPN. The device is an 8300.

Cisco Catalyst SD-WAN Systems and Interfaces Configuration Guide, Cisco IOS XE Catalyst SD-WAN Release 17.x - Cisco Catalyst SD-WAN EtherChannel [Cisco SD-WAN] - Cisco

[Kanan Huseynli]

Hi,

based on document there is no direct restriction. There is need to test with hardware C8K (Virtual does not support portchannel on transport)